Cytron UC00A Uživatelský manuál stáhnout pdf (Strana 12)

ROBOT . HEAD to TOE

Product User’s Manual – UC00A

7. GETTING STARTED

This section will show example on how to use UC00A. Generally, there are 2 methods to use

UC00A. It can be used to connect any 5V UART device to computer, or between 2

computers. Bare in mind that UC00A can be connected to any device which offer 5V UART

interface, this includes microcontroller, RFID reader, wireless module and more.

7.1 Using UC00A with microcontroller

This section will show an example using UC00A. UC00A will be connected to SKPS. SKPS

is a PS2 Controller Converter developed by Cytron Technologies. SKPS can be connected to

PC for functionality test. Normally, user will need to develop RS232 level shifter for

communication to serial port. This will generate extra work just to check the functionality of

SKPS. Furthermore, laptop and computer nowadays have phase-out the serial port, USB have

replaced it. Now, no extra work is required to check the functionally of SKPS. Simply plug

SKPS to UC00A and USB port of computer (PC or Laptop), install driver (1

time) and there

is an extra virtual COM port ready for SKPS. Checking functionality is simple as 1, 2, 3.

a. Simply connect UC00A to SKPS, another end (A type) of UC00A to PC as shown in

following figure. User might need to connect the RX and TX pin to UC00A. Of course,

these two pins should be cross connected to UC00A. In other words, RX of SKPS should

be connected to UC00A’s Transmitter pin (Tx), while TX of SKPS should be connected

to UC00A’s Receiver pin (Rx). No extra component is necessary between these

connections.

Wires in pin 1 and 2 are switch for the second connector.

b. Please refer to document named “USB Driver Installation Guide” for driver installation.

This is mention in section 6.1, software installation.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19

Žádné komentáře

Cytron UC00A Uživatelský manuál Strana 12